Material Safety Data Sheet May be used to Comply with OSHA’s Hazard Communication Standard, 29 CFR 1910.1200. Standard must be Consulted for specific requirements

HMIS

HEALTH 1 REACTIVITY 0

FLAMMABILITY 1 PERSONAL PROTECTION N/A

Identity (As Used On Label and List) B4126 Apple Burst

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for: OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number: 1-800-424-9300

Address (Number, Street, City, State, and Zip Code) 101 Grobric Ct #1

Telephone Number for Information: 1-800-571-7347

Fairfield, CA 94534

Date Prepared 05-09-2010

Signature of Prepare (Optional) REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components (Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-(TWA)

Other Limits Recommended.

%(Opt.)

Isopropanol*

67-63-0

N/A

400 ppm

N/A

5-10%

(odorless mineral spirits)

*This substance is a chemical subject to the reporting requirements of under Section 313 of the superfund amendments and

Reauthorization Act of 1986 SARA Title III and 40 CFR part 372.

Section III - Physical Chemical Characteristics

Boiling Point

212ºF

Specific Gravity (Water = 1) Concentrate

0.988

Vapor Pressure (mm/hg)

Comparable to water

Melting Point

N/A

Vapor Density (Air=1)

Comparable to water (heavier)

Evaporation Rate (Ether = 1)

Comparable to water (slower)

Solubility in Water

Complete

Weight/Gallon ((Water = 8.33#)

8.23#

Appearance and Odor— Clear, thin light red liquid with apple fragrance

%Volatile by Volume

88

Section IV – Fire and Explosion Hazard Data

Flash Point (Method Used)

Flammable Limits

LEL

UEL

None

N/A

N/A

Extinguishing Media – Water fog, foam, gas (CO2, halon) dry chemical.

Special Fire Fighting Procedures –None.

Unusual Fire and Explosion Hazards – None.

Page 2 of 2 for B4126 Apple Burst

Section V – Reactivity Data

Stability

Unstable

Conditions to Avoid – Extreme heat.

Hazardous Polymerization

May Occur

Stable

X

Will Not Occur

X

Incompatibility (Materials to Avoid) – Do not mix with acids or other corrosive liquids or solids.

Hazardous Decomposition or Byproducts –May produce toxic gases upon combustion.

Section VI – Health Hazard Data

Route(s) of Entry:

Eyes? -

Inhalation? Yes

Skin? Yes

Ingestion? -

Health Hazards (Acute and Chronic) – Acute: May cause mild skin and eye irritation. Harmful if swallowed. Chronic: Prolonged skin and eye contact may cause dermatitis and conjunctivitis.

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

N/A

N/A

N/A

Signs and symptoms of Exposure: See Health Hazards above.

Medical Conditions Generally Aggravated – N/A.

Emergency and First Aid Procedures. Eyes—Flush with large amounts of cool running water for at least 15 minutes keeping eyelids apart. If irritation persists, get medical help. Skin—See “Eyes.” Inhalation— No hazard. Ingestion—Drink large quantities of water and induce vomiting, if person is conscious. Get medical attention.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled. Rinse area with water or absorb with floor absorbent, sawdust or rags.

Waste Disposal Method – Flush down sanitary sewer system or place in sealed container and dispose in accordance with federal, state and local regulations.

Precautions to be Taken in Handling and Storing – Do not store at temperature extremes. Keep from freezing. Avoid contact with skin and eyes. Wash thoroughly after use. Do not take internally.

Other Precautions –KEEP OUT OF REACH OF CHILDREN.

Section VIII – Control Measures

Respiratory Protection (Specify Type) – None required.

Ventilation

Local exhaust adequate.

Protective Gloves – Recommended.

Eye Protection – Recommended.

Other protective Clothing or Equipment – None.

Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after product use, eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.