Material Safety Data Sheet

May be used to Comply with OSHA’s

Hazard Communication Standard,

29 CFR 1910.1200. Standard must be

Consulted for specific requirements

HMIS

HEALTH 2 REACTIVITY 0

FLAMMABILITY 3 PERSONAL PROTECTION B

Identity (As Used On Label and List)

A1075 Carb-Clean

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for:

OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number:

1-800-424-9300

Address (Number, Street, City, State, and Zip Code)

101 Grobric Ct #1

Telephone Number for Information:

1-800-571-7347

Fairfield, CA 94534

Date Prepared

12-21-2007

Signature of Prepare (Optional)

REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components

(Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits

Recommended.

%(Wt.)

Toluene

108-88-3

100 ppm

20 ppm

Methanol

67-56-1

200 ppm

Acetone

67-64-1

1000 ppm

500 ppm

Carbon Dioxide Propellant

124-38-9

5000 ppm

Dimethoxpropane

77-76-9

N/E

This product contains the toxic chemicals marked with an * subject to the reporting requirements of Section 313 of the emergency

planning and community Right-To-Know Act of 1986 and of 40CFR372.

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

Section III - Physical Chemical Characteristics

Boiling Point

131ºF

Specific Gravity (H₂O = 1) @ 75ºF

Concentrate

0.815

Vapor Pressure of can (psig @ 70ºF)

N/D

Total VOC

~45%

Vapor Density (Air=1)

N/D

Evaporation Rate (Butyl Acetate = 1)

Solubility in Water

Partial

N/A

Appearance and Odor—Clear colorless liquid, aromatic odor.

Section IV – Fire and Explosion Hazard Data

USA Flame Projection Test (ASTM D-3065)

Flammable Limits

LEL

UEL

Extremely Flammable Spray

<0ºF (T.C.C)

N/L

Extinguishing Media – Foam, CO₂, dry media.

Special Fire Fighting Procedures –Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.

Unusual Fire and Explosion Hazards – Exposure to temperature above 120ºF may cause bursting.

Page 2 of 2 for A1075 Carb Clean

Section V – Reactivity Data

Stability

Unstable

Conditions to Avoid –

N/L

Stable

Incompatibility (Materials to Avoid) - Strong oxidizing agents.

Hazardous Decomposition or Byproducts –Carbon dioxide, carbon monoxide

Hazardous

Polymerization

May Occur

Conditions to Avoid –

N/L

Will Not Occur

Section VI – Health Hazard Data

Route(s) of Entry:

Eyes?

Yes

Inhalation?

Yes

Skin?

Yes

Ingestion?

Yes

Health Hazards (Acute and Chronic) –

See below

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

No

Signs and symptoms of Exposure:

Eyes—May cause irritation.

Skin— Frequent or prolonged contact may cause irritation and defatting of skin. May aggravate skin conditions.

Inhalation—Inhalation of mist can cause irritation of nasal and respiratory passages. Abusive or excessive inhalation may cause irritation to the upper respiratory tract, dizziness, nausea and other central nervous system effects.

Ingestion— Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause pulmonary injury.

Medical Conditions Generally Aggravated –None Known

Emergency and First Aid Procedures.

Eyes—Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. If irritation persists get medical attention immediately.

Skin—Remove contaminated clothing. Wash affected areas with soap and water. If irritation persists seek medical attention.

Inhalation—Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration.

Ingestion—Do not induce vomiting. Seek medical attention immediately.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled.

Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. Keep sparks, heat sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in accordance with Federal state and local law.

Waste Disposal Method – Aerosol cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled. Consult Federal, State and local authorities for approved procedure.

Precautions to be Taken in Handling and Storing –

Store in a cool, dry area away from heat or open flame. Do not store at temperatures above 120ºF.

Other Precautions –Keep out of reach of children.

Section VIII – Control Measures

Respiratory Protection (Specify Type) –

None needed for proper use in accordance with label directions. Use approved NIOSH Organic Vapor Respirator or self-contained breathing apparatus if accumulation of vapors is expected.

Ventilation

Local Exhaust

Adequate

Special

Mechanical (General)

Other

Protective Gloves –

Use chemical resistant gloves if hand contact will be made.

Eye Protection –

Wear safety glasses or chemical proof goggles.

Other protective Clothing or Equipment – None

Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.