Material Safety Data Sheet

May be used to Comply with OSHA’s

Hazard Communication Standard,

29 CFR 1910.1200. Standard must be

Consulted for specific requirements

HMIS

HEALTH 1 REACTIVITY 0

FLAMMABILITY 0 PERSONAL PROTECTION B

Identity (As Used On Label and List)

Q2009 Deep Kleen 2000

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for:

OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number:

1-800-424-9300

Address (Number, Street, City, State, and Zip Code)

101 Grobric Ct #1

Telephone Number for Information:

1-800-571-7347

Fairfield, CA 94534

Date Prepared

07-01-2002

Signature of Prepare (Optional)

REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components

(Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits

Recommended.

%(Wt.)

None

This product is not known to contain any compounds listed and in quantities requiring reporting under SARA Title III

Section 313

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

Section III - Physical Chemical Characteristics

Boiling Point

>212ºF

Specific Gravity (H₂O = 1)

Concentrate

Not Tested

Vapor Pressure (mm/hg)

Not Tested

VOC Content

<10 g/L

Vapor Density (Air=1)

Not Tested

Evaporation Rate (Butyl Acetate = 1)

Not Tested

Solubility in Water

Miscible

Water Reactive

Not Tested

Appearance and Odor— Opaque gray, fragrant odor.

Section IV – Fire and Explosion Hazard Data

USA Flame Projection Test (ASTM D-3065)

Flammable Limits

LEL

UEL

None

N/E

Extinguishing Media – None

Special Fire Fighting Procedures –None

Unusual Fire and Explosion Hazards – None

Page 2 of 2 for Q2009 Deep Kleen 2000

Section V – Reactivity Data
Stability	Unstable				Conditions to Avoid – None
	Stable			X
Incompatibility (Materials to Avoid) – Strong oxidizing agents.
Hazardous Decomposition or Byproducts – Carbon monoxide, carbon dioxide.
Hazardous Polymerization	May Occur				Conditions to Avoid – None
	Will Not Occur			X

Section VI – Health Hazard Data
Route(s) of Entry:	Eyes? Yes				Inhalation? Yes		Skin? Yes			Ingestion? Yes
Health Hazards (Acute and Chronic) – See Below
Carcinogenicity:			NTP?			IARC Monographs?			OSHA Regulated?
			N/A			N/A			N/A
Signs and Symptoms of Exposure: Eyes—Burning sensation. Skin—Slight irritant Inhalation—Not expected to be a problem Ingestion—Irritant
Medical Conditions Generally Aggravated –None Known
Emergency and First Aid Procedures. Eyes— Flush with water for 15 minutes. If irritation persists call physician. Skin—Wash off with water and soap. Inhalation—Not expected to be a problem. Ingestion—Drink large amounts of water, call physician.
Section VII – Precautions For Safe Handling and Use
Steps to be Taken in Case Material is Released or Spilled. Soaked up with absorbent material. Scoop up and place in proper waste disposal container.
Waste Disposal Method – Dispose of in accordance to federal, state, and local regulations.
Precautions to be Taken in Handling and Storing – Store in a cool dry place out of direct sunlight. Do not heat above 110ºF.
Other Precautions –Keep out of reach of children. Follow directions on the container for proper use of this product.
Section VIII – Control Measures
Respiratory Protection (Specify Type) – Open all doors and windows. If exposure is above TLV or PEL. A NIOSH approved respirator equipped for the exposure or suitable respiratory protection per 29CRF 1910.134 is required.
Ventilation		Local Exhaust			Adequate			Special
		Mechanical (General)						Other
Protective Gloves – Plastic or rubber, chemical resistant						Eye Protection – Glasses, goggles
Other protective Clothing or Equipment – None
Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.