Material Safety Data Sheet

May be used to Comply with OSHA’s

Hazard Communication Standard,

29 CFR 1910.1200. Standard must be

Consulted for specific requirements

HMIS

HEALTH 0 REACTIVITY 0

FLAMMABILITY 0 PROTECTION A

Identity (As Used On Label and List)

A1086 Slippery Pull

Note: Blank spaces are not permitted. If any item is not applicable, or no information is available, the space must be marked to indicate that.

Section I

Manufactured for:

OMEGA INDUSTRIAL SUPPLY, INC

Emergency Telephone Number:

1-800-424-9300

Address (Number, Street, City, State, and Zip Code)

101 Grobric Ct #1

Telephone Number for Information:

1-800-571-7347

Fairfield, CA 94534

Date Prepared

12-28-2007

Signature of Prepare (Optional)

REGULATORY DEPT.

Section II - Hazardous Ingredients / Identity Information

Hazardous Components

(Specific Chemical Identity, Common Name(s))

CAS No.

OSHA PEL

ACGIH-TLV

Other Limits

Recommended.

%(Wt.)

Stearic Acid

57-11-4

N/E

Polydimethysiloxane

63148-62-9

N/E

Propylene Glycol

57-55-6

N/E

Triethanolamine

102-71-6

N/E

Isopropyl Myristate

110-27-0

N/E

Liquified Petroleum Gas

68476-85-7

1000 ppm

This product is not known to contain any compounds listed and in quantities requiring reporting under SARA Title III Section 313.

Any substance listed as hazardous by the State of California, Florida, Illinois, Michigan, New Jersey, Ohio, Pennsylvania or

Texas is described above if known present in regulated concentrations.

Section III - Physical Chemical Characteristics

Boiling Point

(aerosol concentrate only)

~212ºF

Specific Gravity (H₂O = 1) @75ºF

Concentrate

1.00

Vapor Pressure of can (psig @70ºF)

VOC %

~5%

Vapor Density (Air=1)

Evaporation Rate (Butyl Acetate = 1)

Solubility in Water

Complete

Appearance and Odor— White foam with perfumed scent.

Section IV – Fire and Explosion Hazard Data

Flash Point

Flammable Limits

LEL

UEL

Non Flammable Spray

None to Boiling (~212ºF – T.O.C) (of concentrate only)

N/A

Extinguishing Media – Foam, carbon dioxide, dry media.

Special Fire Fighting Procedures - Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.

Unusual Fire and Explosion Hazard – Exposure to temperature above 120ºF may cause bursting.

Page 2 of 2 for A1086 Slippery Pull

Section V – Reactivity Data

Stability

Unstable

Conditions to Avoid –

Not Applicable

Stable

Incompatibility (Materials to Avoid) - Strong oxidizing agents.

Hazardous Decomposition or Byproducts –Carbon dioxide, carbon monoxide.

Hazardous

Polymerization

May Occur

Conditions to Avoid –

Not Applicable

Will Not Occur

Section VI – Health Hazard Data

Route(s) of Entry:

Eyes?

Yes

Inhalation?

Yes

Skin?

Yes

Ingestion?

Yes

Health Hazards (Acute and Chronic) –

See Below

Carcinogenicity:

NTP?

IARC Monographs?

OSHA Regulated?

Signs and Symptoms of Exposure:

Eyes— May cause slight irritation but does not injure eye tissue.

Skin— None

Inhalation—None

Ingestion— Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause chemical pneumonitis. Minimal toxicity.

Medical Conditions Generally Aggravated –None Known

Emergency and First Aid Procedures.

Eyes—Flush with large amounts of water for at least 15 minutes, keeping eyelids apart. If irritation persists, get medical attention.

Skin—If, in rare cases, allergic reaction occurs, wash with soap and water. If irritation persists seek medical attention.

Inhalation—Remove to fresh air. Seek medical attention immediately. If breathing stop give artificial respiration.

Ingestion—Do not induce vomiting. Seek medical attention immediately.

Section VII – Precautions For Safe Handling and Use

Steps to be Taken in Case Material is Released or Spilled.

Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. keep sparks, heat sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent material in accordance with Federal, State and local laws.

Waste Disposal Method – Consult local authorities for proper waste disposal procedures. Empty depressurized containers cannot be reused. Cans which are pressurized or contain liquid must be disposed of in a permitted waste management facility. Consult Federal State and local authorities for approved procedures.

Precautions to be Taken in Handling and Storing –

Store in a cool dry area. Keep away from heat or open flames. Do not store at temperatures above 120ºF.

Other Precautions –KEEP OUT OF REACH OF CHILDREN.

Section VIII – Control Measures

Respiratory Protection (Specify Type) –

None needed for proper use in accordance with label directions.

Ventilation

Local Exhaust

Adequate

Special

Mechanical (General)

Other

Protective Gloves –

None

Eye Protection –Always wear safety glasses or chemical proof goggles when working with chemicals.

Other protective Clothing or Equipment – None

Work/Hygienic Practices – Observe good hygiene. Wash hands thoroughly after eating, drinking, and using restrooms, etc.

While the information and recommendations set forth herein are believed to be accurate as of the date hereon Omega Industrial Supply Inc. makes no warranty with respect thereto and disclaims all liability from reliance thereon.